دانلود کامپایلر Bascom AVR 2.0.7.5

۲.۰.۷.۵.۰۰۳
– config eeprom has a new QUICK mode. (xmega only)

2.0.7.5.002
– $hwstack,$swstack and $framesize used with comment like $hwstack=40 ‘500 resulted in wrong values.
– rc5 background option only worked for 8 Mhz

2.0.7.5
– config COM , IRDA baud rate calculation fixed.
– version() with parameter 3 will return file name : Print Version(3)
– xmega autoprog will set lock bit last now.
– RS485 (config print) support added to printbin also changed
– rc5.lib added, sponsored by Lumicon, http://www.lumicoin.de , see config rc5, mode=background
– improved usb read handling for quicker flash programming.
– eeprom programming xmega/PDI mode fixed.
– $stackdump added. See also stackdump.bas. Based on code from MWS.
– history.txt is shown once for each new version of the IDE
– ERR is set to 1 when there is not enough frame space. you use frame space when using locals and
passing parameter byval. also a test like : if left(string,3)=”value” will use temp space.
– added link to the bascom-avr.xml file location in the Help, About window.
– boot loader samples improved : bblocklocal incremented after a valid block.
– huge memory on Xmega bug fixed : rampX and r12 inside an ISR were not preserved.
– config xram for xmega, fixed bug for sram mode. also, baseadr changed, see help.
– $timeout help updated (it works for SW UART too), and INPUT with $timeout added to SW UART.
– spiinit, will set only miso to output when slave mode is selected.
– w5200 support added.
– W5100 tcp/ip support added.
– w5300 tcp/ip support added.
– xmega : saving watchdog cause in r0 was not implemented. also, the flags were not cleared at start up.
– an updated version of bascomp.exe was not included in the release.
– sample files are now located in usersUSERDocumentsMCS ElectronicsBASCOM-AVRSamples
– split screen editor fixed.
– added CAN support. See CONFIG CANBUS, CANMOB, CANBAUD,CANRESET, CANSEND, CANRECEIVE,etc.
– removed backspace from INPUT.
– added M8U2 and M16U2 support
– fixed RTC32 and added new sample from MAK3. See XM256A3BU-RTC32.bas
– STCHECK checking framesize (error 3) did not work. So you could get error 3 while there was no error.
– DTMFOUT did not saved r23 which could lead to erratic behavior for chips with TIMSK in high IO regs.
– documented LCDCMD and LCDDATA
– When adding files in Project Mode, you can select multiple files using CTRL/SHIFT.
– Adding a CONSTANT _CHECKVAL with a value <>0 will test for illegal chars in VAL()
Const _CHECKVAL =1 : Dim S as string * 10 : s = “1234a” : w = val(s) : print ERR
– config clock, gosub=sectic option was sensitive to position.
– user sub/functions calls are protected against interrupts. See $noframeprotect
– xmega config event_system : portA and portB were reversed. ADCB_CH0/ADCB_CH3 would result in a wrong setting too.
– config servos has a new mode to use servos with less system load. this mode works on xmega as well.
– using an overlay array with config base=0, would result in the wrong overlay address.
– full version can run updatewiz from the IDE